UConnect Navigation Board Installation
NavBoard Replacement . . its easier to replace your RHB Navigation Board than to replace your RHB System.
Ben in Michigan said "The board works great and it came with updated maps. A win-win all the way around. Thanks so much !"
Troubleshooting . . If your system is stuck on Acquiring Satellites after you install the Navigation Board, it means the coaxial antenna cable is not securely snapped into its connector on top of the board.
Check your Maps Version after installation.
Instructions
Removing your RHB unit from your vehicle (10-20 minutes) Return to Navigation Board Page Removing the dashboard trim surrounding your RHB unit is unique for each vehicle so it helps to have some instruction to identify the boundaries of the removable trim. Open https://youtube.com and search for something like "remove radio from 2015 jeep wrangler". You will find videos showing how to remove your RHB unit from your car. The videos will usually span a few vehicle model years. If your dashboard has a glossy or metallic finish that could be scratched while you disconnect the cables from the head, tape a dish towel or similar to your dashboard just under the radio. Be Aware, all of the connectors on the back of your system have a release latch that must be depressed before the connector can be pulled out. It requires a lot of hand-strength to remove some of the connectors. If necessary, use a small screw driver or knife point to pry a little on each end of a connector. Replacing the Navigation Board (5-10 minutes) Remove the top cover with 2 screws See next photo to unlatch the cover Turn a small blade screw driver in the slot shown to unlatch the top cover Remove the CD drive with 4 screws But first, see next photo to protect your ribbon cables Caution - Don't stress the ribbon cable or its connections Use finger tips to pull up (un-snap)
antenna connector from the Navigation Board.
Don't pull on the wire Remove the Navigation Board and its metal shield with 3 screws You are now ready to seat the replacement Navigation Board with its two connections to the Main Board.
double
check to make sure the antenna connector is seated correctly -
it must be pressed into its socket perfectly vertical. If not vertical, it
may feel
like it snapped into place but won't work.
|